ILUMINARC Ilumipanel™ 180 IP - Manual (Page 15)

Installation
Ilumipanel 180 IP Optic 15/30 RGB User Manual Rev. 3 11
To assign
individual DMX
addresses to each
product, you must
connect the Ilumicode to
each product, individually.
ILUMINARC®
suggests that you
connect no more
than 20 products
in this mode and keep the
total distance to less than
60 m (197 ft.). Otherwise,
you might need to use an
optically isolated signal
amplifier.
ILUMICODE ADDRESSER
The Ilumipanel 180 IP Optic 15/30 RGB uses the ILUMICODE ADDRESSER
(“Ilumicode”) for configuration purposes. The diagram below shows how to connect the
Ilumicode to this product. This connection will control multiple products at the same time,
all having the same DMX address.
Important: The Ilumicode must be used to configure this product. The Ilumicode
can be purchased separately through your ILUMINARC® sales representative.