ILUMINARC Ilumipanel™ 180 IP - Manual (Page 11)

Installation
Ilumipanel 180 IP Optic 15/30 RGB User Manual Rev. 3 7
Always connect
the Ilumipanel
180 IP Optic
15/30 RGB to a protected
circuit with an appropriate
electrical ground to avoid
the risk of electrocution or
fire.
Never connect
the Ilumipanel
180 IP Optic
15/30 RGB to a rheostat
(variable resistor) or
dimmer circuit, even if the
rheostat or dimmer
channel serves only as a
0% to 100% switch.
Make sure to
connect the
Ilumipanel 180
IP Optic 15/30 RGB to a
power line with the proper
voltage and frequency, as
per the specifications in
this manual or on the
product’s sticker.
AC Power
The Ilumipanel 180 IP Optic 15/30 RGB has an auto-ranging power supply that can work with
an input voltage range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the specifications in
this User Manual or on the product’s sticker.
Power Consumption
To determine the power requirements for the Ilumipanel 180 IP Optic 15/30 RGB,
refer to the label affixed to the side of the product. Alternatively, you may refer to the
Technical Specifications .
The listed current rating indicates the maximum current draw during normal operation.
AC Plug
The Ilumipanel 180 IP Optic 15/30 RGB comes with a bare-ended power input cord
for hardwire installation. Use the table and the illustration below to wire a plug.
Connection Wire (U.S.) Screw Color (U.S.) Wire (Europe) IP67 Pin
AC Live Black Yellow or Brass Brown 1
AC Neutral White Silver or Gray Blue 2
AC Ground Green/Yellow Green Green/Yellow 3
The listed
current rating
indicates the
maximum
current draw during
normal operation.
If you choose to
bury the power or
signal distribution
boxes, make sure that
they are IP67-rated or
greater.
Power Wiring
You can connect the bare-ended, IP67-rated AC power cable from the product to an
IP67-rated power connector or IP67-rated junction box.
If using junction boxes, make sure to use IP67-rated conduit for surface installations.