Controllers, Dmx controller, Installation – ILUMINARC Ilumipanel™ 90 IP User Manual
Page 14
Installation
10
Ilumipanel 90 IP Optic RGB User Manual Rev. 2
If you have not
configured the
DMX starting
address and
DMX mode for each
product, they will all use
their default values. This
means that all products
will operate in unison.
Caution:
W-DMX™
operation can be
interrupted or
inhibited by liquid masses
between the transmitter
and receiver such as
water, snow, or people.
For best results, please
keep the antenna clear of
any liquid mass.
Controllers
The Ilumipanel 90 IP Optic RGB can operate with a standard DMX controller, the ILUMICON
controller, or the ILUMICODE ADDRESSER. The sections below provide information on how
to connect these products to the corresponding controllers. The instructions to operate these
products with each of the above controllers are in
Operation
. You may also choose to connect
these controllers via W-DMX™. Refer to the W-DMX™ transmitter instructions provided with
your transmitter and the
section of this manual to use this method.
DMX Controller
The Ilumipanel 90 IP Optic RGB can work with a standard DMX controller. The
channel assignments will depend on the chosen personality (see the corresponding
section) and the DMX address assigned to each product (see the
section).
The figure below illustrates how to connect the DMX controller to the Ilumipanel 90 IP
Optic RGB.