W-dmx™ calibration, Installation – ILUMINARC Ilumipanel™ 90 IP User Manual
Page 13
Installation
Ilumipanel 90 IP Optic RGB User Manual Rev. 2
9
The
ILUMICODE
ADDRESSER is
required to send DMX
addressing and
personality information to
the fixture.
Once
W-DMX™ has
been enabled,
you cannot
use the Ilumicode to
make changes to the
Ilumipanel 90 IP Optic
RGB. Changes made via
the Ilumicode should be
done prior to enabling
W-DMX™. The W-DMX™
takes priority control over
the wired DMX cables.
Caution:
W-DMX™
operation can be
interrupted or
inhibited by liquid masses
between the transmitter
and receiver such as
water, snow, or people.
For best results, please
keep the antenna clear of
any liquid mass.
W-DMX™ Calibration
You can run the Ilumipanel 90 IP Optic RGB without DMX cabling using the W-DMX™ option.
This product can operate in W-DMX™ mode up to 900 ft. (300 m) from the W-DMX™
transmitter. For wireless operation, the W-DMX™ receiver in the Ilumipanel 90 IP Optic RGB
must be paired with the W-DMX™ transmitter. Use the following instructions to operate:
1. Using the ILUMICODE ADDRESSER, set the personality and the DMX address to the
Ilumipanel 90 IP Optic RGB (see the
2. Disconnect power and the ILUMICODE ADDRESSER from the product.
3. Open the cover next to the W-DMX™ Antenna by unscrewing the six (6) Allen Screws
using a 3-mm angled Allen Key.
4. Reconnect power to product.
5. Press and hold the W-DMX™ button until the Green LED stops flashing.
6. Disconnect power to the product for approximately 10 seconds.
7. Reconnect power to product.
8. Locate the product by using the W-DMX™ transmitter (see the W-DMX™ transmitter
instructions provided with your transmitter).
9. Upon locating the product wirelessly, close the cover.
10. Tighten the Allen Screws uniformly by alternating between opposite screws to insure a tight
seal.