ILUMINARC Ilumipanel™ 28 IP - Manual (Page 12)

8 Ilumipanel 28 IP Optic RGB User Manual (Rev. 6)
4. O
PERATING
I
NSTRUCTIONS
Menu Map (Ilumicode-remote addresser)
M AIN F UNCTION S UB -F UNCTION S ELECTION I NSTRUCTION
DMX address 001~512 Sets the DMX starting address
Personality
Remote
For use with optional controller (see website for
more information)
ARC 1 3-channel RGB color mixing
ARC 1+D 4-channel RGB + dimmer
ARC FULL 7-channel RGB + dimmer, Color Macro, Strobe
Calibration
White (1~11)
Red
Green
Blue
(0~255)
Edit white color of different color temperatures
RGB
Red
Green
Blue
(0~255)
Modify RGB dim to White values
Dimmer
Off No function
Dim1
Select between 4 dimmer curves for the fixture Dim2
Dim3
Dim4
Static
Red
Green
Blue
Strobe (0~20 Hz)
(0~255)
Combine the different attributes to create a static
scene
Operation
This fixture requires the Ilumicode remote addresser to change the starting address, change the
personality, change the dimming curve, or to set the fixture to operate on a static program. Please
see the below instructions for this process.
1) Plug the Ilumicode into the DMX in.
2) Press the power button.
3) Modify the settings as desired.
4) Press the enter key after each setting modification.
5) The fixture should light green when a setting has been successfully changed, and remain lit for
15 seconds.
· You must press ENTER after each setting modification in order to properly send the setting to
the fixture
·
You may only modify a maximum of up to 20 fixtures at a time with the Ilumicode. However,
each fixture that is attached will have the same identity. In order to have individual addressing,
connect 1 fixture at a time.
· The Ilumicode will automatically power off after being idle for 1 minute.