Future Automation EAD2 - Manual (Page 12)

In
st
al
la
ti
o
n
:
S
ta
ge
7
Page 11 of 18 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
EAD2 - Electric Advance & Drop V2
Turn the captive bolts simultaneously or turn by turn to alter the tilt position.
Tighten the internal bolts and locking nuts and run the EAD2 back into the up
position to see the tilt alteration. It may be necessary to repeat this procedure
a few times until the desired tilt has been acquired.
Tilt Adjustment (If Required)
TURN BOLT CLOCKWISE -
BOTTOM TILTS OUT
TURN BOLT ANTI-CLOCKWISE -
BOTTOM TILTS IN
IN OUT
Once tilt position is set tighten the internal
bolts and locking nuts back up