Future Automation LSM-FSE - Manual (Page 14)

In
st
al
la
ti
o
n
:
S
ta
ge
9
Page 13 of 20 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
LSM FSE/PSE EFA -
Lift System with FSE or PSE Mount & Electric Flap Actuator
You can adjust the IN and OUT position of the lifting beam. Detail 1 shows how
to adjust the OUT position and detail 2 shows how to adjust the IN position.
The IR sensor can be located anywhere outside of the cabinet.
Lift Switch Adjustments
1
2
1 - The top switch can’t
be adjusted when the
mechanism is in the OUT
position, because the
switch is active. Lower
the mechanism and press
STOP about 100mm [4”]
and then adjust the OUT
switch plate.
2 - Height of the lower post
determines the IN position