Sl27 pg11 – Drylam SL27 Roller Laminator User Manual
Page 13
Shut the machine off! SL27’s have set screws at both ends of each laminating and pull roller. With
the use of a 3/32 hex key, loosen all four set screws on the pull rollers. Cut the plastic between the lami-
nating and pull rollers, grab the loose end and pull. The rollers will rotate freely on the roll shafts and the
“wrap-around” will easily unwrap. Tighten all the set screws and rethread the film.
Appendix A
Replacing the hand held Cutter Blades.
The hand held cutter blade can be replaced
by removing the small screw on the back of
the cutter, then removing the cutter back.
Caution: The cutter blade is extremely
sharp. Please handle carefully and dis-
pose of properly. Remove and discard the
old blade. Re-install cutter back and screw.
Caution: Do not over tighten screw.
11