Drylam SL27 Roller Laminator - Manual (Page 12)

B. Specific Troubleshooting Guide
C. Removing a “Wrap-Around”
A “wrap-around” occurs if the film exiting
the rear rollers curls around one of them
causing the laminate to wind around the
roller.
If the wrap-around is not severe, simply
use the reverse feature and back the film
out. Make sure to remove the Feed Table
before reversing the machine!
For extreme wrap-arounds (i.e. when plas-
tic and/or product have wrapped around
the rubber rollers several times) follow this
procedure:
10
Increase HeatDecrease Heat Worn, Dirty, Or
Damaged Rollers
Increase Tension
On Supply Rolls Dirty Heat Shoes
Moist Or
Coated Product Decrease Tension On Supply Rolls Check Threading
Diagram
Wrinkles on Film (side to side)
Wrinkles on Film (lengthwise)
Plastic not bonding
Bubbles or Blisters
Impressions on product
Squeaking sounds
Film narrowing on shoes
Film wrinkling on shoes
Continuous blemish
Cloudy film
“Orange Peel” Finish
Film sticks to rollers
Film sticks to shoes
Film won’t stay aligned
No seal on edges
Poor seal - one side only