Doremi ShowVault / IMB - Manual (Page 9)

SHV.OM.002220.DRM Page 9 of 13 Version 1.1
Doremi Labs
2.2 Hardware Setup
1. If using the Master and Slave configuration, connect the SDI Out-A of the Master IMB to the
SDI IN-A of the slave IMB (Figure 6).
2. If using an embedded Timecode source and a DA, connect the SDI outputs of the DA to the
SDI IN-A of each slave IMB (Figure 6).
Figure 6: IMB SDI In And Out
2.3 Software Configuration
After the hardware setup is complete, each Slave IMB needs to be configured to chase using the
ShowVault GUI. To configure the Slave IMB for Chase:
1. Using the ShowVault GUI, o pen the Macro Editor from Menu → Doremi Apps.
2. Press the green “+” button in upper-left to create a new macro (Figure 7).
3. In the pop- up window, name the Macro “Chase On” and press “OK” to create the Macro
(Figure 8).
Figure 7: Macro Editor on Slave Unit
Save
Button
Create Macro
Button
SDI IN-A SDI OUT-A
Insert Action
Button