Datapath VSN970 - Manual (Page 9)

Use of the SBC’s onboard graphics adaptor
Onboard Graphics Adaptor used as Control Screen
The VSN970 is shipped with the BIOS configured to boot off the onboard graphics device. This output can
then be used as the control screen for a typical wall configuration.
To set the system to boot on the onboard graphics device (“ nitiate Graphic Adapter” - IGD), enter setup
from the boot screen by pressing as prompted.
In the BIOS setup utility select:
Advanced>Graphic Configuration>Graphics Configuration>Primary Display Selection>Initiate Graphic
Adapter - [IGD]
Onboard Graphics Adaptor Disabled
If you do not require a control screen, then you should disable the integrated graphics as described below.
Connect a monitor to the onboard graphics device output and enter setup from the boot screen by
pressing as prompted.
In the BIOS setup utility select:
Advanced>Graphic Configuration>Graphics Configuration>Primary Display Selection [PEG/PCI]
9
Fig.4