Datapath VSN890 - Manual (Page 16)

The LED’s indicate the following:
• Flashes on for 1.5 seconds then off for 0.5 seconds.
This indicates that the full lane width has been established for that slot e.g. x4 card in a x4 slot
• Flashes on for 0.5 seconds then off for 1.5 seconds.
This indicates that a reduced lane width has been established and the slot is not working to maximum
efficiency e.g. a x1 card inserted into a x4 slot.
• No LED’s flashing.
This indicates that lane width has not been established.
The LED’s will not flash on slots where no cards are installed.
VSN890 Series Approved Accessories
The items below are UL Listed Accessories for VSN890 series machines. Use of these plug-in cards within
VSN890 and Vision800X chassis, to build custom systems, will maintain the UL listed status for the sys-
tem. The cards can be used in any combination, in any order, in any slots on the backplane(s) without los-
ing the approval.
Image4 Quad-screen graphics card
VisionRGB-E1S Single channel HD video capture card
VisionRGB-E2S Dual channel HD video capture card
VisionSD8 Eight channel SD video capture card
VisionSD4+1S Combination video capture card with 4 channels of SD and 1 channel of HD
VisionSDI2 Dual channel HD-SDI video capture card
VisionDVI-DL Single channel Dual-Link video capture card
VisionAV Simultaneous HD, SD video and composite video capture
H-Link Host Link card for expansion racks
S-Link Slave Link card for expansion racks
ExCable Cable for expansion racks
16