Dataman 770 Series - Manual (Page 20)

Development kit for DATAMAN 770 series
Programmer’s Guide
level – determines level of the affected trigger system
TRIGGER_LEVEL_PRIMARY – primary level
TRIGGER_LEVEL_SECONDARY – secondary level
source – determines the source, whose sensitivity is affected
TRIGGER_SOURCE_A – channel A
TRIGGER_SOURCE_B – channel B
TRIGGER_SOURCE_E – external trigger input
edge – determines sensitivity
TRIGGER_EDGE_LEADING – sensitivity on the leading edge
TRIGGER_EDGE_TRAILING – sensitivity on the trailing edge
Return value: -
3.3.13. SetProbe
Sets device to measure with selected probe accurately.
void __declspec(dllimport) __stdcall SetProbe(int channel, int probe);
Parameters:
channel – determines channel
CHANNEL_A – channel A
CHANNEL_B – channel B
probe – determines connected probe
PROBE_1_1 – probe 1:1
PROBE_1_10 – probe with attenuation 1:10 or higher
Return value: -
Remark:
This function sets correction of the input impedance inaccuracy. This correction is
turned on with probes with attenuation of 1:10 or higher.
3.3.14. SetMemorySize
Sets length of memory used for data acquisition.
void __declspec(dllimport) __stdcall SetMemorySize(int size);
Parameters:
size – length of memory used for data acquisition (valid values are: 1024, 2048, 4096,
8192, 16384, 32768, 65536, 131072, 262144, 524288 and 1048576)
Return value: -
3.3.15. SetCompensationGenerator
Turns compensation generator (square wave with frequency of 1.465kHz on the E
connector) on/off.
- 20 -