Dual XD5210 - Manual (Page 2)

XD5210 INSTALLATION
Preparation
Please read entire manual before installation.
Before You Start
• Disconnect negative battery terminal.
(consult a qualified technician for instructions)
• Avoid installing the unit where it would be subject to high temperatures,
such as from direct sunlight, or where it would be subject to dust, dirt or
excessive vibration.
Getting Started
• Remove 2 transit screws located on top of the unit.
• Remove trim ring by pulling up gently in the center.
• Insert the supplied keys into the slots as shown, and slide the unit out of the
mounting sleeve.
• Install mounting sleeve into dash opening, bending tabs to secure.
• Connect wiring harness and antenna.
(consult a qualified technician if you are unsure)
• Certain vehicles may require an installation kit and/or wiring harness
adapter (sold separately).
• Test for correct operation and slide into mounting sleeve to secure.
• Snap trim ring into place.
2