Dynalink A 0977A - Manual (Page 5)

are received within 15 seconds, the unit will exit learning mode.
NOTE 3.
Except LEARN and device buttons, any button can be programmed, and programmed more
than once. The unit will retain the last code programmed.
To delete any programmed buttons
1.Press the device key.
2.Press and hold the learn button, then press the device button you wish to clear. After 2
seconds. The LED indicator will flash 3 times signifying the data has been deleted.
To delete all the data in a device key
Press and hold the Learn button, then press MUTE button. After 2 seconds, the LED
indicator will flash 3 times and all the learned data will be deleted.
To reset the remote
Go into code programming mode (see ‘A. Inputting the brand code number’). When in
programming mode input the device key 9901. The LED indicator will flash twice and the
remote will go back to its original factory preset.
5