Dynalink A 0977A - Manual (Page 2)

2
B. Using Code manual search.
1. Press and hold the device key button you want to program (eg TV, STB etc) for 3 seconds
until the LED indicator remains illuminated.
2. Release the device key.
3. Turn on device (eg TV) using your existing remote.
4. Face the remote control to the appliance. Press and release the “left” or “right” button.
Each pressing of the button sends a different “Off” command to the appliance. Repeat
this action until the TV powers Off.
5. Press the OK button.
C. Using Auto Code search.
1. Press and hold the device key button you want to program (eg TV, STB etc) for 3 seconds
until the LED indicator remains illuminated.
2. Release the device key.
3. Turn on device (eg TV) using your existing remote.
4. Face the remote control to the appliance. Press the Power button and release and the
remote control will send a “power off” signal to your device every 2 seconds.
5. When the remote control finds the correct device type by powering off your device, press
the OK button. The LED indicator will no longer be illuminated.
Note 1
Every time you begin the autosearch, it will begin searching from the last code. Once the
unit has outputted every code, the LED indicator will extinguish and quit searching. Hence
it may be necessary to start the search again from the beginning.
Note 2
During searching, you may press “LEFT” (search backwards) or “RIGHT” button (search
forwards).
Note 3
You can use “MUTE” button instead of the “Power” button to find the code for your device.
When the code is found the “mute” function will be enabled.
D. Using popular brand name code search.
1. Turn on device (eg TV) using your existing remote.
2. Press and hold the device key. Whilst holding the device key press the number that
corresponds to your device brand as per the chart Fig 1 (page 3). Continue holding the
2 buttons on.
2. Turn on device (eg TV).
3. The remote control will now send a “power off” signal to your device every 2 seconds. The
LED indicator will flash every 2 seconds denoting it is sending the code to your device.
4. When your device “powers off” release the 2 buttons.
Note 1.
The searching begins from the lowest code number (as per the codes list), to the highest
code number, and will stop searching when it has done all code numbers as per your
selected “key no” in fig 1.
Note 2.
During searching, you may release 1 button.