d&b Z5398 YP Horizontal bracket - Manual (Page 6)

1.5. Assembly
Attaching the bracket to walls or ceilings
NOTICE!
Only use mounting parts (fixing anchors and screws) that are
suitable for the intended application.
Observe the occurring extraction forces acting on the fixing
anchors and screws. The rated extraction forces for the respective
application (wall or ceiling mounting) and cabinet are listed in the
following table.
Application Rated extraction forces
Wall mounting 300 N
Ceiling mounting 200 N
To attach the bracket to walls or ceilings, use the holes shown in
the graphic opposite to provide adequate support.
A corresponding fixing template is supplied with these mounting
instructions. Refer to Þ Chapter 2. "Fixing template"
on page 7.
Attaching the cabinet to the bracket
NOTICE!
Only use the supplied and specified screws [2], otherwise there a
risk of damaging the threaded inserts.
Always use the spring washers
[3] and U washers [4] to prevent
the bolts from slackening.
Tools required:
– Open-ended spanner/wrench (size #17)
1. Attach the cabinet to the prepared bracket.
2. Insert the screws together with the spring and U washers.
3. Align the cabinet and tighten the screws.
d&b Z5398 Mounting instructions 1.1 en 6