d&b Z5394 Y Flying adapter User Manual

Page 7

2. Attach the Flying adapter
1. Attach the Flying adapter on top of the cabinet until the Front

links of the cabinet fit into the slots at the front of the adapter.

2. Insert and lock the Locking pins of the cabinet's Front links on

both sides.

3. On the rear align the Flying adapter with the

[0°] hole of the

rear rigging strand.

4. Insert and lock one Locking pin in the

[0°] hole.

Note: The second Locking pin is not needed and can be

stored in one of the remaining holes.

3. Prepare the next cabinet
1. Prepare the Front and Splay links of the next cabinet.

4. Preset the splay angle
The splay angles between adjacent cabinets are set at the central

rear rigging strands of the cabinets and can be set in the range

from 0° to 14° in 1° steps.

Þ Preselect the splay angle according to your ArrayCalc

simulation and insert and lock one Locking pin in the

appropriate hole.

d&b Z5394 Rigging manual 1.1 en