Attachment, Vertical aiming of the first cabinet – d&b Z5386 V Stack adapter User Manual

Page 5

1.3.1. Attachment

The Stack adapter is attached to the rear rigging strand of the

V-SUB cabinet. To attach the adapter, proceed as follows:

1. Release the two Locking pins on the rear rigging strand of the

V-SUB cabinet.

2. Attach the Stack adapter as shown in the graphic opposite.
3. Reinsert and lock the two Locking pins on the V-SUB cabinet.

1.3.2. Vertical aiming of the first cabinet

The hole grid on the Stack adapter allows the first V-TOP cabinet

on top of the V-SUB cabinet to be set to a fixed vertical angle of –

7°, –3.5°, 0° or +7°. For this purpose, the hole (drill) of the

cabinet's Splay link is used. It supports the cabinet and defines the

angle setting.

d&b Z5386 V Stack adapter, Rigging manual (1.1 EN)