d&b Z5385 V Flying adapter - Manual (Page 5)

2.1. Suspension options
The center bar of the adapter is equipped with a total of 27 holes
to allow the suspension of the array and the setting of different
vertical angles.
The holes are numbered with an increment of five.
Single or dual pick point operation
The array can be suspended using one or two E6507 1t shackle(s)
and appropriate lifting devices or steel wire ropes.
With "Dual pick point operation" the vertical aiming of the entire
array is set by trimming the respective lifting devices.
With "Single pickpoint operation" the total vertical aiming of the
entire array is defined by using a particular hole of the hole index
of the center bar.
The corresponding hole position is calculated using the d&b
ArrayCalc calculator software. For this purpose ArrayCalc can be
downloaded at www.dbaudio.com .
Note: The use of ArrayCalc is described in "TI 385 d&b Line
array design, ArrayCalc" which is included in the ArrayCalc
software. The TI can also be downloaded at
www.dbaudio.com .
Within ArrayCalc the closest pickpoint hole and the exact distance
in cm/in is displayed on the "Rigging plot page" in the "Array data
section" (last entry) provided the corresponding array is selected
on this page.
Z5147 Rota clamp option
Alternatively, the array can be suspended and horizontally aligned
from a single pickpoint using the d&b Z5147 Rota clamp. The
clamp allows the load to be attached to overhead bars or truss
with a tube diameter of up to 51 mm (2”).
Attachment
Choose the appropriate hole position in the center bar according
to the ArrayCalc calculation and attach the Rota clamp
correspondingly.
Note: Please observe the relevant mounting instructions
which are enclosed with the Rota clamp.
2. Assembly
d&b Z5385 V Flying adapter, Rigging manual (1.3 EN) 5