d&b Z5372 T Horizontal bracket - Manual (Page 5)

5. Assembly
Fig. 5: Tie bar of the bracket
Fixing to walls or ceilings
NOTICE: Only use appropriate mounting parts (anchors and screws)
that are suitable for the intended application.
Two mounting holes 6.5 mm (0.26") are provided on the back of the
bracket for fixing the bracket directly to walls or ceilings or other
suitable surfaces.
Fig. 6: Insert rubber washers
Attaching the bracket to the cabinet
NOTICE: Only use the screws supplied and specified [2]. Always
use the spring washer [3] and the U washer [4] to
prevent the bolts from slackening.
Ensure the two rubber washers
[5] are inserted on both
sides between the cabinet and the bracket.
Tools required: Open-end spanner/wrench (size #17).
1. Fit the cabinet to the prepared bracket.
2. Bolt the bracket to the cabinet.
3. Align the cabinet before finally tightening the screws.
Z5372 Mounting instructions (1.0 EN) Page 5 of 8