d&b Z5147 Rota Clamp - Manual (Page 4)

Preparations
The desired position in the rigg as well as the total vertical angle of the
assembly should be defined in advance. The total vertical angle can be
set via the holes grid of the respective adapter or frame.
Function of the securing pin (Rue ring cotter)
Release Remove/
Fit
Snap in Lock
Fig. 3: Function of the Rue ring cotter (schematic diagram)
Fitting to Flying adapter/Flying frame
[1b]
[1a]
Fig. 4: Z5147 Rota Clamp assembly with
Z5156 Q Flying adapter
1. Unlock and remove the ring cotter [1a] of the fixing bolt and
remove the fixing bolt [1b].
2. Attach the Rota Clamp to the respective hole of the flying adapter
or flying frame.
[1a]
Fig. 5: Fixing bolt secured
3. Insert the fixing bolt [1b] and secure the bolt with the ring cotter
[1a].
4. Recheck your work and ensure the ring cotter [1a] is properly fitted
to the fixing bolt - Fig. 5.
6. Installation
CAUTION! Installation must only be to horizontal tubes. Never fit
the clamp at an angle other than straight down.
With the Rota Clamp fitted to the assembly as described above, the
assembled unit is now ready to install.
Proceed as follows:
Z5147 Mounting instructions (2.2 EN) Page 4 of 8