d&b MAX2 - Manual (Page 5)

2.1. Product description
MAX2 is a 2-way stage monitor employing a 15"/1.4" coaxial
driver combination with a passive crossover. The driver design
allows the use of a compact, low height cabinet.
Coaxially mounting the 1.4" HF compression driver and the 15" LF
driver using a single magnet assembly creates a very compact
driver with 75° constant directivity HF dispersion.
With a frequency response extending from 55 Hz to 20 kHz, the
MAX2 can be used individually as a full range system, or it can be
supplemented by different d&b subwoofer systems such as the Y-
SUB, V-SUB or B6-SUB.
The cabinet is constructed from marine plywood and has an impact
resistant paint finish. The front of the loudspeaker cabinet is
protected by a rigid metal grill in front of an acoustically
transparent foam. Each side panel incorporates a handle while
four M10 threaded inserts allow connection to different rigging
devices and brackets. A pole mount is incorporated in one side
panel to accept a loudspeaker stand. Two runners recessed in the
bottom panel prevent cabinet movement and protect the bottom
panel against scratching.
2.2. Connections
The cabinet is fitted with NLT4 F/M connectors. All four pins of
both connectors are wired in parallel. The cabinet uses the pin
assignments 1+/1–. Pins 2+/2– are designated to active
subwoofers. Using the male connector as the input, the female
connector allows for direct connection to a second cabinet.
The cabinet can be supplied with NL4 or EP5 connectors as an
option.
Pin equivalents of the connector options are listed in the table
below.
NLT4 F/M
NL4
1+ 1– 2+ 2– n.a.
EP5 1 2 3 4 5
Connector wiring
2. MAX2 loudspeaker
d&b MAX2 Manual 1.1 en 5