CUE Wireless IR Control Panels - Manual (Page 16)

User Manual Wireless IR Control Panels
www.cuesystem.com
Page 16 of 26
The address of the receiver can be set up by the Address Switch - see picture above. BUTTON_ID
sent by irCUE Receiver 485 to the control unit is a BUTTON_ID sent by IR wireless control panel with
an added OFFSET value. Button ID and OFFSET value are calculated according formulas below.
BUTTON_ID (irCUE Receiver 485) = Offset + BUTTON_ID (IR wireless control panel)
Offset = 32 * ADDRESS
ADDRESS is binary coded by DIP switch in the range 0 to 255.
ON
1 7 6 5 4 3 2 8
SW1 – ADDRESS bit 0
SW2 – ADDRESS bit 1
SW3 – ADDRESS bit 2
SW 4 – ADDRESS bit 3
SW 5 – ADDRESS bit 4
SW 6 – ADDRESS bit 5
SW 7 – ADDRESS bit 6
SW 8 – ADDRESS bit 7
ADDRESS of irCUE Receiver 485 OFFSET SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8
0 0 OFF OFF OFF OFF OFF OFF OFF OFF
1 32 ON OFF OFF OFF OFF OFF OFF OFF
2 64 OFF ON OFF OFF OFF OFF OFF OFF
3 96 ON ON OFF OFF OFF OFF OFF OFF
...
255 8 160 ON ON ON ON ON ON ON ON