Delta 50-760 - Manual (Page 8)

8 - English
ATTACHING THE CASTERS
1. Turn the stand (A) upside down (Fig 1).
2. Place a 3/8” lockwasher on the caster stud (B).
Screw the caster into the threaded hole on the
bottom of the stand. Repeat for the other three
casters.
3. Tighten the caster by hand, then secure it with a
thin 14mm wrench.
1. Place the motor/blower assembly with the motor
down (A) Fig. 2.
2. Place a 5/16” flatwasher on the knob (B).
3. Align the holes in the legs (C) with the holes (D) in the
motor/blower assembly. The legs should extend up.
Insert the knob through hole in the legs (C) and into
the threaded hole in the motor/blower assembly (D).
Tighten the knob securely.
4. Repeat these steps for all knobs on both legs.
This machine is heavy. Use two or more people when lifting.
Fig. 1 Fig. 1
UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil
from unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol. Do not
use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your machine. After cleaning,
cover the unpainted surfaces with a good quality household floor paste wax.
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
ASSEMBLY TOOLS REQUIRED
Phillips head screwdriver 12 mm wrench
30 minutes to 1 hour
ASSEMBLY
ATTACHING THE LEGS TO THE MOTOR/BLOWER ASSEMBLY
B
C
A
D
Fig. 2 Fig. 2
B
A
ASSEMBLY TIME ESTIMATE