Delta 50-760 - Manual (Page 10)

10 - English
USING CLOTH COVERED FLEXIBLE RING:
1. Place the cloth-covered bag retainer ring (A) Fig. 8 inside the opening of the clear plastic dust collection bag.
Fold about 6 inches of the bag around the retainer ring.
2. Place the bag in the large hole (B) Fig. 8 in the motor/blower assembly. Fit the retainer ring (A) Fig. 8 and (A)
Fig. 9 into the bottom groove (B) Fig. 9. Bend and fold the ring to fit it into place.
3. Tug slightly on the bag to eliminate any slack and to make sure that the bag is secure and will not detach
during collection.
B. USING A METAL BAG CLAMP
You can also attach the plastic bag to the outside of the dust collector using the included clamp (B) Fig. 10.
1. Place the clamp (B) around the top of the plastic bag (A). Fold about 4 to 6 inches of plastic bag over the
clamp (Fig. 10).
2. Place the clamp and plastic bag (A) Fig. 11 on the blower assembly. Fasten the clamp (B) securely.
Place the dust intake port (A) Fig. 7 on the intake flange
(B) opposite the motor. Make sure that the dust intake
port is snug on the intake flange.
Turn the unit over so that the casters are on the
ground.
Because of the weight of the unit, use
more than one person to lift the motor/blower assembly
into the upright position.
ATTACHING THE DUST INTAKE PORTS
Disconnect the machine from the power source!
A
B
ATTACHING THE
DUST COLLECTION BAG
Disconnect the machine from the power source!
A
B
A
B
A
B
A
Fig. 7 Fig. 7
Fig. 8 Fig. 8 Fig. 9 Fig. 9
Fig. 10 Fig. 10 Fig. 11 Fig. 11