DeVillbiss Air Power Company D26368 - Manual (Page 9)

9- ENG D26368
ASSEMBLY
Assembly for “Pancake” units
Tools Required for Assembly
1 - 3/8” socket or nut driver
1.
Carefully place unit on side opposite of
controls.
2. Using a 3/8 inch socket or nut driver
remove the screws attaching the unit to the
shipping pallet.
NOTE: These screws will be used to install the
rubber feet.
3.
Attach the rubber feet to the unit’s legs
using the screws removed in step 2. NOTE: Units will have three or four
feet.
NOTE: Flat side of rubber feet goes against unit legs.
4. Tighten snug or until rubber foot begins to compress.
Leg
Rubber
Foot
Screw
Some models require no assembly. Select the picture below of your unit and
follow the assembly instructions for that unit.
CONTRACTO R SERIES
LA-3182
2 HP
4 GAL
LA-3184
2 HP 4 GAL
L A -3 1 8 0 MAXIMUM AI R CONTRACTOR SERIES AIRE M`XIM O L˝NEA PARA CONTRATISTA S
1-800-888-246 8 Ext. 2
“Hotdog” unit -requires
no assembly
“Sidestack” unit -
requires no assembly “Pancake” unit
“Horizontal” unit
(some “horizontal”
units are equipped
with a console)
“Vertical” unit