Dual XD6150 - Manual (Page 6)

6
Faceplate Removal
Semi-Permanent
Faceplate Installation
Power On/Off
Mode
Auxiliary Input
USB Charging Port
Volume
Mute
Reset
Display
Press RELEASE and pull away from the left side to remove.
To re-install, insert right side of faceplate first then push
left side to secure.
Remove trim ring and install supplied #1 x 7/32” Phillips
head screw through left side of mounting frame into faceplate.
Press or any other button (except eject) to turn the unit on.
Inserting a disc will turn the unit on automatically. Press
to turn the unit off.
Press MODE to select between AM/FM, CD player and
auxiliary input. Modes of operation are indicated in the
display.
Note: CD mode will not appear unless a CD is inserted.
Insert a 3.5mm connector in the front panel AUX port.
Connect the other end of the 3.5mm connector to the
headphone output of an audio device, MP3 player, etc. Press
MODE to select AUX mode.
Insert the USB connector of a battery-powered USB device
into the USB charging port on the front panel, which provides
5 volts DC and 1.0 amps. The USB device will immediately
begin charging.
Note: The USB charging port may not be compatible with
every device due to differences in power requirements.
Note: This USB port provides power only and will not play
back music from a USB device.
Adjust volume using volume knob (00-46).
Press MUTE to silence the audio. “MUTE” will flash in the
display. Press MUTE again to cancel.
Press to RESET the unit upon initial installation or if
abnormal operation occurs. The reset button is located
behind the faceplate.
Press DISP to select between clock and different types of
information, such as radio frequency or CD track information.
XD6150 OPERATION
General Operation