Directed Electronics 440HP - Manual (Page 18)

QUICK REFERENCE GUIDE
To lock/arm using your remote
➤
To arm the system press for one second. The doors will lock (if
connected). The LED will begin to flash. The Failsafe® Starter Kill will
prevent the vehicle’s starter from cranking if it has been installed. The vehi-
cle’s horn (if connected) will honk and the parking lights will flash once to
confirm arming of the system.
To unlock/disarm using your remote
➤
To disarm the system press for one second. The doors will unlock (if
connected). The Failsafe
®
Starter Kill will be deactivated and the vehicle’s
horn (if connected) will honk twice and the parking lights will flash twice.
Disabling the Failsafe ® Starter Kill without a transmitter
➤
Turn on the ignition. Press and release the Valet
®
switch within 10 seconds.
The LED will stop flashing and the vehicle should start.
To enter or exit Valet ® Mode
➤
Turn the ignition to the ON position. Turn the ignition back off. Press and
release the Valet
®
switch within 10 seconds. The status LED will light steadily
if you have entered Valet
®
Mode. To exit Valet
®
Mode, repeat the steps above.
The LED will turn off when exiting Valet
®
Mode.
To activate Panic Mode
➤
Press and hold for 2 seconds.
To exit Panic Mode
➤ Press on the transmitter.
Location of Valet Switch___________________________________
Cut along dotted line and f
old f
o
r a quick and eas
y
r
efer
ence to k
eep in y
our pur
se or w
allet.
✂
✂