Directed Electronics 440HP - Manual (Page 12)

8 © 2 0 0 2 d i r e c t e d e l e c t r o n i c s , i n c .
disabling the system without a transmitter
If your remote transmitter is lost or damaged, you can manually
override the system. To do this, you must have the vehicle's igni-
tion key and know where the Valet ® switch is located. Be sure to
check with the installer for the location of the Valet ® switch.
To disarm the security system, turn
the ignition to the ON posi-
tion. Press and release the
Valet switch within 10
seconds. The status LED will
stop flashing and the vehicle
should start. If the vehicle
does not start, you may have
waited too long; turn the ignition off and repeat the
process.
Location of Valet Button_________________________________
silent mode
To temporarily turn off the arm or disarm chirps, use Silent
Mode™. Simply press for less than one second before
arming or disarming, and the confirmation chirp(s) will be elim-
inated for that one operation only. If you want the arm/disarm
chirps turned off permanently, your dealer can do this for you.
➜
DRW-35
➜