Dixon 7000 Series - Manual (Page 11)

Page 11
CHASSIS: 11 GA - rectangular tube
BODY: Folded sheet metal.
SEAT: Designed for operator comfort with padded back and arm rests. Seat is
adjustable fore and aft.
MOWER DECK: 2 Decks are available. Both decks are made of 10 GA fabricated welded
construction with 7 GA reinforcement plate. 3 blades combine for either
a 52" or 60" cut width. Cut height approximately 1.5" to 5" via 7 position
lift handle.
BLADE DRIVE: Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDU-10L
Series 70 hydrostatic transmission. The hydrostatic transmissions, in
turn, power a fully enclosed HydroGear gearbox.
ENGINE: 25HP Kohler Command, 4-Cycle, V-Configuration, Overhead Valve,
Air-Cooled, Gasoline, Vertical Shaft, Aluminum Head, and Crankcase
with Cast Iron Liners, Full Pressure Lubrication/Full Flow Filter, Pulse-
type Fuel Pump, Fixed Jet Carburetor w/Smart-Choke, Electronic Ignition,
In-Line Fuel Filter, Dual Element Air Cleaner.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake
and blade drive clutch.
TIRES: Front 13-5.00x6
Rear 23-9.50x12
RECOMMENDED Front 12 lbs.
TIRE PRESSURE: Rear 12 lbs.
CAPACITIES: Fuel - 11 gallons (approx)
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 36
Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS: Width 61"(52" Deck), 69-1/2"(60" Deck)
Height 43"
Length 81" (52” Deck), 81” (60” Deck)
Weight 915 lbs.(48" Deck), 916 lbs.(60" Deck)
NOTE: Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
SPECIFICATIONS
7000 Series