COMMELL FS-961 - Manual (Page 14)

2.2 CPU and DRAM Setting
The board is based on Intel socket 370 Pentium-III / Celeron architecture
supports Intel FC-PGA and VIA C3 CPUs at 66/100/133 MHz of FSB. The
FSB, ratio and voltage of CPU is default set by CPU without any additional
jumper selection. The CPU should be installed into the CPU ZIF socket.
The board supports PC100/133 SDRAM up to 1GBytes of memory
capacity on two 168-pin DIMM sockets DIMM1 and DIMM2.
2.3 CMOS Setting
The board’s data of CMOS can be setting in BIOS. If the board refuses to
boot due to inappropriate CMOS settings, here is how to proceed to clear
(reset) the CMOS to its default values.
Jumper: JRTC
Type: onboard 3-pin header
JRTC Mode
1-2 Clear
CMOS
2-3 Normal Operation
Default setting
1
JRTC
FS-961 User’s Manual 14