Dixon 4000 Series - Manual (Page 34)

34
CARE AND MAINTENANCE
CHANGING THE ENGINE OIL:
1. The “Dapco” oil drain valve is located on the left
side of the engine crankcase.
2. Place a suitable container under the drain valve
hose.
3. To drain, turn hex head valve stem counter--
clockwise with 10mm wrench or socket. Open
to full open (approximately 7 turns).
4. After engine is drained, tighten hex stem.
5. Change the oil filter.
6. Fill with oil (see steps on next page).
NOTE: Refer to engine manufacturer’s recommendations
for frequency of oil changes.
HOT oil may cause burns. Allow
engine to cool before draining oil.
CAUTION
Hex Head Valve Stem