Brennenstuhl Multifunction Detector WMV Plus - Manual (Page 9)

9
WMV Plus Operating Instructions
NOTES:
1. The device is not suitable for use on walls or ceilings that are
insulated with elements containing metallic fibres or on slab walls
and surfaces with thick plastering.
2. It is important to check the location of the stud again through,
other readings.
3. The object detected inside the wall can also possibly be an electrical
wire, a pipe or something else. For this reason, you should use
extreme caution when drilling, sawing or hammering nails since you
could hit a pipe or electrical wire. For safety’s sake, take other
readings in the »metal« and »alternating current« modes.
4. Keep your hand away from the device when it is in operation, in
order to prevent interference and inaccurate readings.
Detecting Metal
1. Turn the selector switch to the right to »
ተ«,
to select the function »metal«.
2. Set the device on the wall. Press and hold the on
button »
ቱ« (either on the side or on the front) and
wait until the LCD-display reads »00« , which
signals that the calibration is complete and the
device is ready to use.
3. Move the device slowly and evenly sideways.
4. Keep moving the detector across the surface until the numbers in the
display go up, i. e. 01, 02, 03…, which should be accompanied by a
signal tone that speeds up. Stop moving when the numeric values on
the display drop again.
Metallic Object Reading increases
Maximum value
008709 Metallsuchgerät WMV Plus_008709 BA_Metallsuchgerät WMV Plus 18.07.14 11:44 Seite 9