Brennenstuhl Multifunction Detector WMV Plus - Manual (Page 10)

10
Operating Instructions WMV Plus
5. Move the detector back slowly until the registered
value shows the highest number again.
Then release the on button »
ቱ«.
6. Mark the location with a pencil.
NOTES:
1. The device is not suitable for use on walls or ceilings that are insu-
lated with elements containing metallic fibres or on slab walls and
surfaces with thick plastering.
2. The device cannot detect water pipes made of plastics.
3. Electrical wires in insulator pipes made of PVC or metal will be
displayed as »Metal« .
4. The depth to which the device can detect metal depends on the
type of the material and the size of the object. Larger objects can
be detected at greater depths.
Detecting Alternating Current
1. Turn the selector switch to »
ተ« in the middle
position, to select the »alternating current« func-
tion.
2. Hold the detector way from the test object and
other sources of electricity. Press and hold the on
button »
ቱ« (either on the side or on the front) and
wait until the LCD-display reads »00«, which signals
that the calibration is complete and the device is
ready to use.
3. the device over the test object, such as electrical
outlets, plugs, wires, etc. Increasing numbers in
the display i.e. 01, 02, 03… and a more rapid signal
tone indicate alternating current. Watch the
location of the sensor range »
ቩ«.
Pencil
Maximum value
008709 Metallsuchgerät WMV Plus_008709 BA_Metallsuchgerät WMV Plus 18.07.14 11:44 Seite 10