2 affixing the house number, 3 replacing/installing the battery – Brennenstuhl Illuminated House Number Solar Power SH 4000 E with external solar panel User Manual

Page 18

Solar power with external solar panel

User's Handbook SH 4000 E

Stand:

06_2011 rev. 02

Step 11:

Connect solar cell to circuit
board

Plug the connecting lead into the socket in
the solar panel.

Fig. 6: Solar panel

On completing the installation, remove the
protective foil from the solar cell.

Period of illumination:
Dull days: up to 5 hours
Sunny days: over 9 hours

7.2 Affixing the house

number

Step 1:

Remove pull-off foil

Remove the pull-off foil from the protective
paper.

Step 2:

Affix the house number to
the pull-off foil

Affix the house numbers/letters (incl. the
protective paper) to the adhesive-coated
side of the pull-off foil.

- For 3-digit numbers, use the red
characters.
- For 2-digit numbers, use the blue
characters.

Pull off the protective paper from the
numbers/letters. These are also coated
with adhesive.

Step 3:

Affix pull-off foil to window

Affix the pull-off foil to the window with
uniform lateral and vertical spacings.

NOTE: Take care to ensure that the

pull-off foil lies flat and is evenly attached.

Press down the house numbers/letters on
to the window.

Step 4:

Remove the pull-off foil

Remove the foil carefully and slowly. The
house numbers and letters will now be
permanently affixed to the window.

7.3 Replacing/installing

the

battery

The house number light is powered by a
battery. It needs no additional power supply.

Step 1:

Separate the two parts of
the light

See Section 7.1

Step 2:

Remove the old battery

Remove the battery from the battery holder.

NOTE: Observe the disposal

instructions (Section 10).

Step 3:

Install new battery

IMPORTANT: Install battery [3] in the

battery holder [8], observing the correct
polarity.

Fig. 7: Control electronics, including battery

Step 4:

Reassembling the light

See Section 7.1