1 installation – Brennenstuhl Illuminated House Number Solar Power SH 4000 E with external solar panel User Manual

Page 17

Solar power with external solar panel

User's Handbook SH 4000 E

Stand:

06_2011 rev. 02

7.1 Installation

Step 1:

Open up the house
number light

Unscrew and remove the screws [14] from
the underside of the light using a small
Phillips-type screwdriver.

Fig. 4: Underside

Step 2:

Mark out the mounting
holes

Using the rear panel as a template, mark
out the mounting holes [14] with a pencil.

Fig. 5: Rear view

Tip: Use a spirit level when marking

out the mounting holes. This will
subsequently ensure that the light is
mounted horizontally.

Step 3:

Drill mounting holes

DANGER: When drilling and

installing screws, take care to avoid
damaging electricity cables and gas and
water pipes. This could lead to severe
injuries and damage.

NOTE: Obtain suitable fastening

materials from an appropriate retail outlet.
Example:
Drill two mounting holes (6 mm diameter) in
the substrate and insert suitable plugs.

Step 4:

Mount the rear panel

Secure the rear panel to the substrate.

TIP: Use a spirit level to adjust the

rear panel so that it is level.

Step 5:

Affix the house number

See Section 7.2

Step 6:

Install battery

See Section 7.3

Step 7:

Fit the house number light

With a small Phillips-type screwdriver,
install the screws [14] on the underside of
the house number light.

Step 8:

Mark out the mounting
holes

NOTE: It is advisable to mount the

solar panel in a position where it is exposed
to direct sunlight. The duration of
illumination depends on the intensity of the
sunlight.

Using the mounting base as a template,
mark out the mounting holes with a pencil.

Step 9 :

Secure the solar panel

DANGER: When drilling and

installing screws, take care to avoid
damaging electricity cables and gas and
water pipes. This could lead to severe
injuries.

NOTE: Obtain suitable fastening

materials from an appropriate retail outlet.

Example:
Drill two mounting holes (6 mm diameter) in
the substrate and insert suitable plugs.

Step 10:

Lay the connecting lead

CAUTION: Take care to ensure that

the connecting lead does not become a trip
hazard.