beautypg.com

Installation / wiring – Brennenstuhl Chip LED Light L CN 150 PIR IP44 with PIR sensor 50W 3500lm Energy efficiency class A User Manual

Page 7

background image

7

User Manual

L903 IP 55 / L903 PIR IP 55

Installation / Wiring

• Use the base plate to mark the drill holes in the desired location.

Drill the marked holes and ensure not damaging hidden pipes or cables.

• Feed the mains power cable through the rubber grommet.

Make sure that no water can get into the light.

• Attach the base in the desired location using suitable wall plugs and

the mounting parts included with the product.

• Observe the cable diagram for wiring and ensure proper connection

of cables and screws.

This light must be earthed!

• Attach the light to the base using the cap bolt included with the

product.

Maintenance instructions:

Do not open the LED unit. The LEDs cannot be replaced.

Any contact can damage the LEDs.

Immediately replace a damaged protective cover.

Do not use the light without flawless protective cover.

First remove the rubber gaskets over the screws for the protective

cover on the back of the light. Then loosen the screws to remove the

damaged protective cover and put a new one on. To make sure that it

is water tight, you must put the rubber gaskets back in place.

Clean light and motion detector with a damp cloth, if necessary.

Do not use any chemicals or aggressive

agents for cleaning the device.

L903 PIR IP 55 only:

Light system setting

At the bottom there are 2 control knobs.

Power supply

Earth

(green/yellow)

Neutral

(blue)

Phase

(black or brown)

To fitting

Earth
(green/yellow)

Neutral
(blue)

Phase
(black or brown)

079612 BA_LED-Strahler L903 07.05.13 12:04 Seite 7