Delta 50-763 - Manual (Page 9)

9
Place the dust intake port (A) Fig. 7 over the intake hole
(B) opposite the motor. Align the four holes (C) (two of
which are shown) in the port with the ones in the motor/
blower assembly (D). Fasten them with four M4 sheet
metal screws.
Turn the unit over so that the casters are on the
ground.
Because of the weight of the unit, use
more than one person to place it into the upright
position.
The previous instructions have shown how to assemble the unit with the motor on top and dust intake ports on bottom
(Fig 4).
You can also assemble this unit with the intake port (B) Fig. 5 in the up position by following the steps in “ATTACHING
THE LEGS TO THE MOTOR/BLOWER ASSEMBLY.” The difference in assembly is in placing the motor/blower
assembly on a flat surface with the motor (A) Fig. 5 facing up, and attaching the legs in that position.
NOTE: Before using the alternate set-up, remove the 5/16” hex head screws from holes (B) Fig. 6 in the motor/blower
assembly and place them in the holes (C). Air will leak if the screws are left out of these holes.
Disconnect the machine from the power source!
ALTERNATE SET-UP
Fig. 4
Fig. 7
Fig. 6
Fig. 5
B
B
C
A
ATTACHING THE DUST INTAKE PORTS
A
B
C
D