Delta 50-763 - Manual (Page 11)

11
5. Insert the rod into the pocket on the filter bag (A) Fig.
13.
6. Insert the rod in the hole in the bracket (B).
7. Work the open end of the filter bag into the top
groove of the dust collector drum until it is secure
and sealed. Bend and fold, as necessary, the internal
bag retainer ring to fit it into place.
8. Attach the other filter bag in the same manner.
Models 50-762/50-763 provide four 4” dust ports.
NOTE: Place the intake cap rings (D) Fig. 14 on the ends
of each dust intake port before attaching the hose.
Loosely place a hose clamp (A) Fig. 14 around one end
of the flexible hose (B). Attach the hose to the dust
intake port (C). Tighten the hose clamp (A). Attach the
remaining clamp to the other end of the flexible hose
and to the woodworking machine.
NOTE: Do not operate the dust collector with any of the
holes in dust intake port (C) Fig. 14 uncovered. To cover
a hole not being used by a hose, place the flat intake
cap (E) on dust intake port as shown in Fig. 14.
ATTACHING THE ACCESSORY HOSE TO THE INTAKE PORT
Disconnect the machine from the power source!
A
B
A
C
D
B
E
SINGLE- AND THREE-PHASE WIRING
Use a qualified electrician to install this machine to ensure safe and proper wiring and product
operation.
DIsconnect power at source before wiring the machine.
Your dust collector must be permanently connected to
the building’s electrical system and grounded to meet
code.
1. To connect the dust collector to a power system,
remove the controller cover (A) Fig. 15.
2. Bring the three-phase power line through the access
hole (B) Fig. 15 in the bottom of controller box.
MODEL 50-762 THREE PHASE INSTALLATION (230 VOLT OPERATION)
A
B
Fig. 13
Fig. 14
Fig. 15