Audio Solutions AS-P-601 - Manual (Page 4)

POWER SOLUTION 1000 Page 6 Page 5 POWER SOLUTION 1000
oPeraTIon
lCd Panel
The Power Solution 1000 is equipped with an LCD Panel (Figure 4) that allows the user
to monitor input voltage and output current.
20 5 . 0 VOLTS CURRENT
Figure 4 - LCD Panel
• “VOLT” indicates the input voltage from the AC wall outlet.
• “AMPS” indicates the output current from the outlet banks.
led Indicators
The LED indicators on the front panel (Figure 5) allow you to monitor important
power and safety information.
GROUNDED PROTECTED SWITCHED
POWER
Figure 5 - Front Panel LED Indicators
• “GROUNDED” indicates the status of the AC outlet. Green indicates that the AC
wall outlet is properly grounded.
• “PROTECTED” indicates the status of the Power Solution surge protection. Orange
indicates that the surge protection is turned on.
• “SWITCHED POWER” indicates whether the “Switched” outlets are ON or OFF.
remote Trigger operation
This power solution can be controlled remotely by another power solution equipped
with a remote trigger out feature. To use remote trigger control, connect the remote
DC cable from the “DC OUT” connection on the power solution equipped with remote
trigger out to the “DC IN” connection (Figure 6) on the Power Solution 1000.
Figure 6 - DC IN Connection
sPeCIfICaTIons
Width 482.6mm
Height 44mm
Length 220.1mm
Weight 3.5kgs
Power Cord 14 AWG with 36 degree angle
(8 Feet)
Electrical Rating 120V/15A
Clamping Voltage L-N 400V, L-G 500V, N-G 500V
Surge Energy Joule Rating 2160J
Maximum Peak Spike Current 144000A
Maximum Spike Voltage 6KV
EMI/RFI Noise Filter X2 Capacitor (uF) 1.0uF*1; 0.22uF*1
Coil (T) 1mH*1
Frequency (KHz) 150KHz~100MHz
Attenuation (dB) up to 65dB
DC Trigger Input Jack ψ 3.5
Voltage 3~30V
Current Requirement 10mA
Tel/Fax/Modem Energy (Joules) 160J
Let Through Voltage (V) <40V
DSS/COAX Cable
Protection
Surge Arrestor Gas Tube
Breakdown Voltage <75V
Insertion Loss @10MHz <0.1dB
RF Connectors 3 Pairs, Gold finish
NOTE: Specifications subject to change without notice.