Panel description, Electrical box – Atlona AT HDWP RSNET User Manual

Page 4

atlona.com

Toll free: 1-877-536-3976

Local: 1-408-962-0515

LINK

HDMI OUT

ETHERNET

AT-HDWP-RSNET

PWR

IR IN

RS232

IR OUT

Panel Description

1. HDMI Out Port: Connect to HDMI display.
2. IR IN Port: Connect included IR receiver to this port.
3. IR OUT Port: Use the included IR Emitter for this port.
4. Ethernet Port: Bi-directional Ethernet pass through, send signal from a router to a source or to a
display.
5. Green Power LED: Power indicator. If plugged in, light will remain solid. If LED starts blinking
power is intermittent or there is a problem with the cable. If LED is off, no power is passing from
the transmitter (check the outlet on the transmitter or check the CAT cable).
6. Yellow Link LED: Signal Indicator for the CAT5e/6/7 IN port. LED will remain solid, unless there
is an issue with the cable or signal, then it will blink.
7. Firmware Update Port: Use Mini USB to USB A cable to connect to a Windows computer to
update.
8. RS-232 Port: Receive signal from a control system or PC.
9. CAT5e/6/7 IN Port: Connect category cable from here to a compatible transmitter.
Ex. AT-HDTX-RSNET (recommended), AT-HDCAT-8ED, etc.

Electrical Box

Compatible electrical boxes (see below)

Type: Plastic old-work electrical box or mud ring
Size: 2 Gang
Dimensions: Inner opening must be greater than 3.58” wide and 2.68” high