Dukane Projector 8112 User Manual

Page 14

Replacing the internal clock battery

Consumption of the battery makes the clock not to work correctly. When the clock
is wrong or it has stopped, please replace the battery according to the following
procedures.

Turn the projector off, and unplug the power cord. Allow the
projector to cool sufﬁciently.

After making sure that the projector has cooled adequately,
slowly turn over the projector, so that the bottom is facing.

Turn the battery cover fully in the direction indicated “OPEN”
using a coin or the like, and pick the cover up to
remove it.

Pry up the battery using a ﬂathead screwdriver or the like
to take it out. While prying it up, put a ﬁnger lightly on the
battery since it may pop out of the holder.

Replace the battery with a new HITACHI MAXELL or
HITACHI MAXELL ENERGY, Part No.CR2032 or CR2032H.
Slide the battery in under the plastic claw, and push it
into the holder until it clicks.

Replace the battery cover in place, then turn it in the
direction indicated “CLOSE” using such as coins, to ﬁx.

WARNING ►Always handle the batteries with care and use them only as

directed. Battery may explode if mistreated. Do not recharge, disassemble or
dispose of in ﬁre.

And also improper use may result in cracking or leakage, which could result in
ﬁre, injury and/or pollution of the surrounding environment.

Be sure to use only the batteries speciﬁed.

Make sure the plus and minus terminals are correctly aligned when loading a battery.
Keep a battery away from children and pets. If swallowed consult a physician

immediately for emergency treatment.

Do not short circuit or solder a battery.
Do not allow a battery in a ﬁre or water. Keep batteries in a dark, cool and dry place.
If you observe battery leakage, wipe out the leakage and then replace a battery. If the

leakage adheres to your body or clothes, rinse well with water immediately.

Obey the local laws on disposing a battery.

OPEN

Battery Cover