Atlona AT HD14SS - Manual (Page 7)

5
DIP SWITCH
Mode for EDID/Audio setting
DIP Switch Position
Video Audio Description
Pin-1 Pin-2
OFF [ ] OFF [ ] Up to 1080p Stereo 2
Default Mode 3 – Up to 1080p & stereo audio output
for most HDTVs
OFF [ ] ON [ ]
Up to
720p/1080i
Stereo
Safe Mode
4
– Enforce the system output at
720p/1080i video and stereo audio for basic
compatibility among HDTV
ON [ ] OFF [ ] Bypass
5
Bypass
5
EDID Learning 6 Mode – for learning EDID from the
display while playing any received HDMI audio
format
ON [ ] ON [ ] Bypass Stereo
EDID Learning 6 & Stereo Mode – for learning EDID
from the display while enforcing stereo output if any
HDTV cannot play surround sound normally
Note:
1 If the HDTV shows video but without audio, please try to set audio mode to stereo.
2 Factory default setting of Mode is pin-1 [OFF ] & pin-2 [OFF ] for 1080p with stereo.
3 If you encounter any unsolved audio/video output problem during system installation, please turn
any Mode to pin-1 [OFF ] & pin-2 [ON ] for safe mode to enforce the most compatible 720p
stereo output for system check. However, the safe mode cannot be initiated if your HDMI source
is set to enforce 1080p output. In this case, please reconfigure your HDMI source to all
resolution output for troubleshooting.
4 Bypass means the distribution amplifier will maintain playing the original format of HDMI
signals in video and perhaps audio. By setting at this mode, the users may encounter
compatibility issue among different kindsof HDMI sources and displays. If you cannot get the
audio and/or video output normally at the system installation, please change the DIP switch
setting to default mode or even safe mode to verify the functionality of the device.
5 To learn the EDID of HDMI display for respective HDMI source devices, set pin-1 at [ON ] first
then connect the HDTV sets to the HDMI INPUT via HDMI cable. Then please wait for 20
seconds for completing the EDID learning procedure. If you want to learn the EDID from
another HDTV, you must set pin#1 at [OFF ] first and repeat this procedure all over again.