Panel description, Hardware installation – Atlona AT HD14SS User Manual

Page 6

PANEL DESCRIPTION

1. DIP Switch: see more detail in the next section (p.5)

2. HDMI INPUT: Connect to one HDMI source here

3. HDMI Signal OUTPUT 1 – 4: Link to each HDMI display via a Cat-5/5e/6 cable with a

HDMI over CAT5 receiver AT-HDRS or AT-HD15SRS

4. USB: For firmware update use (for technical support only)

5. +5V DC: Power jack for 5V DC

HARDWARE INSTALLATION

Broadcast HDMI signal to 4 remote HD displays from one video source

1. Switch off each device, including displays devices.

2. Connect the HDMI source (such as a PS3, HDMI Compliant Set-top Box, Blu-ray player)

to the HDMI INPUT.

3. Connect to each receiver (AT-HDRS or AT-HD15SRS) via RJ-45 connector by CAT5e

cable.

4. Plug in 5V 4A DC power supply unit.

5. Power on the HDMI displays.

6. Power on the HDMI source.

1 2