Dacor MOV230 - Manual (Page 11)

9
Planning the Installation
Electrical Specifications
IMPORtANt
Preheat times and cavity temperature recovery times
•
will be increased slightly if operating on less than a
240 Vac circuit.
This appliance is provided with electrical connec-
•
tion leads in a flexible metal conduit. These leads
may be a smaller gage than the standard household
wiring of the dedicated supply circuit, but they are
suitable for connection to these circuits under the
jurisdiction of the National Electric Code, and/or the
local inspection authority.
Locate the junction box so that the wiring may be
•
disconnected without removing the oven from the
wall.
It is the owner’s responsibility to ensure that a qualified
electrician performs the electrical connection of this appli-
ance. The electrical installation, including minimum supply
wire size, must comply with the National Electric Code
ANSI/NFPA 70 (latest revision) and local codes and ordi-
nances.
*A copy of this standard may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, Massachusetts 02269-9101
The correct voltage, frequency and amperage must be sup-
plied to the appliance from a dedicated, grounded, single
phase circuit that is protected by a properly sized circuit
breaker or time-delay fuse. If a time-delay fuse is utilized,
fuse both sides of the line (L1and L2).
Model type
Dedicated Circuit
Required
total
Connected Load
Single 27” 240 Vac, 60 Hz
4 wire 30 Amp
Dedicated
4.6 kW (19.5 Amp)
Single 30”
Double 27” 240 Vac, 60 Hz
4 wire 50 Amp
Dedicated
9.25 kW (38.9 Amp)
Double 30”
The above electrical ratings are for reference only. For the
exact ratings see the appliance data plate. See page 3 for
location.
Installation Instructions
Parts List
Exhaust deflector with three (3) screws
•
Mounting screws, four (4) for single ovens, six (6) for
•
double ovens, two (2) different sizes may be included.
Standard oven racks two (2) for a single oven, five (5)
•
for a double oven
GlideRack™ oven rack, one (1)
•
Broiler grill and pan
•
Meat probe, one (1)
•
Ceran cleaning kit
•
Stainless steel cleaner (stainless steel models only)
•
Light lens pry stick
•
Ease form
•
Quick start guide
•
Installation instructions
•
Use and care manual
•
Verify that all the parts are included. If any item is missing
or damaged, please contact your dealer immediately.
Make certain that you have all tools and parts necessary to
ensure a proper installation before proceeding. If replace-
ments parts are required, contact your Dacor dealer.