Atlona AT HDSync - Manual (Page 5)

4 www.atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Display Side
1. Connect to a 5V DC power supply unit.
2. Red light indicates the power on/off status. Green light indicates if the AT-HDSync is in the process of
reading or writing EDID or sync detection.
3. Connect to a HDMI™ display.
Source and Control Side
1. Connect to a PC for RS-232 serial control to read/write EDIDs from/ to the display
2. Connect to a HDMI™ source device so the AT-HDSync will be the bridge between the HDMI™ source
and display
3. Mode 0 = [Video] – supports up to HDMI 1.3 output. [Audio] – supports up to 7.1ch output
Mode 1 = [Video] – supports up to HDMI 1.3 output. [Audio] – lock to stereo audio output
Mode 2 = [Video] – locks to HDMI 1.2 output. [Audio] – supports up to 7.1ch output
Mode 3 = [Video] – locks to HDMI 1.2 output. [Audio] – lock to stereo audio output
Mode 4 = [Video] – DVI display mode. [Audio] – no audio output
Mode 5 = [Safe Mode] – uses default EDID with video supported up to 1080p
Mode 6 = [Recording Mode] – Learning EDID from HDMI output manually
Mode 7 = [Serial Control Mode] – Control the AT-HDSync by software via RS-232
1 2 3
PANEL DESCRIPTION
1 2 3