Atlona AT UHD CLSO 824 User Manual

Page 25

atlona.com

Toll free: 1-877-536-3976

Local: 1-408-962-0515

Command

Feedback

Description

EDIDMSetX default
Ex. EDIDMSet3 default

EDIDMSetX default
Ex. EDIDMSet2 default

Sets the input EDID to default X=Input
Ex. Set input 2 EDID to default

EDIDMSetX saveY
Ex. EDIDMSet7 save2

Set input X EDID to the saved EDID memory (Y)
Ex. Set input 7 to the EDID saved to memory 2

EDIDMSetX intZ
Ex. EDIDMSet3 int7

Set input EDID to the chosen internal EDID (Z)
Ex. Set input 3 to the internal EDID 7

EDIDMSetX sta
Ex. EDIDMSet6 sta

EDIDMSetX sta
Ex. EDIDMSet6 default

Displays the current EDID (Y) of the selected input (X)
Ex. Input 6 is set to default EDID

EDIDOutX memY
Ex. EDIDOut2 mem1

Copies EDID from an output (x) to a chosen memory location (y)
Ex. Sets output 2 EDID to EDID memory 1

PrefTimg8 Y
Ex. PrefTimg8 3

Set the preferred timing of the VGA port Y=0-7
Ex. Set the VGA port to 1024x768

PrefTimg sta

PrefTimg8 Y

Displays the preferred timing for the VGA port

List X
Ex. List Pref

List X
Ex. Pref 0: Default
Pref 1 : 1280x800
etc

Displays the preferred timings (Pref) and EDIDs (EDID) available

HDCPSetX Y
Ex. HDCPSet5 Off

Sets HDCP reporting mode of the HDMI input port Y=on,off,sta
Ex. Set input 5 to HDCP non-compliant

Internal EDIDs -
01 2160P60 Multi CH

02 2160P60 2CH

03 2160P30 Multi CH

04 2160P30 2CH

05 1920x1200 RGB 2CH 06 1080P DD

07 1080P Multi CH

08 1080P 2CH

09 1080P 3D DD

10 1080P 3D Multi CH 11 1080P 3D 2CH

12 1080P DVI

13 1280x800 RGB 2CH 14 1280x800 RGB DVI 15 1366x768 RGB 2CH
16 1024x768 RGB 2CH 17 720P DD

18 720P 2CH

19 800x600 RGB 2CH

Prefered Timings -
00 Default

01 1920x1200

02 1920x1080

03 1280x800

04 1366x768

05 1024x768

06 1280x720

07 800x600

RS-232 Command for the Output baud rate status

RS232para

The RS-232 status command will provide feedback for the current parameters for each transmitter/
receiver.

Example: (See example of feedback below)

RS232para
Current RS232 parameters:
- Zone 1-15 :BaudRate 2400bps, DataBits 0, Parity None, StopBits 1.

Note: Zone 1-10 are the captive screw connectors, Zones 11-13 are the HDBaseT inputs, and Zones 14-15 are the
HDBaseT outputs.

Note: Default for the transmitters/receivers is: Baud-9600bps, Data length-8bit, Parity-None, Stop Bit-1