Atlona AT UHD EX 100CE - Manual (Page 6)

6
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
FW LINK
POWER
AT-UHD-EX-100CE-RX
RS-232
RXTX
IR IN
P S
IR OUT
S
HDBaseT IN
ETHERNET
HDMI OUT
RX
1. Ethernet - Connect to a display to send Ethernet signals
2. Firmware - Use a Mini-B USB to USB A cable to connect to a Windows computers for updating
3. Yellow Link LED: Signal indicator for the HDBaseT IN port
Solid - Good signal from the CAT port
Blinking - CAT port is disconnected or not receiving a signal
No Light - No signal is being received from the CAT port
Green Power LED: Power indicator
Solid - Plugged in and receiving power
Blinking - Power is intermittent or there is a problem with the cable
No Light - No power is passing from the transmitter to the receiver
Note: Check the category cable or the AC outlet for the transmitter
4. RS-232 - Bidirectional RS-232, send signal to or from a control system, PC, source, or display
5. IR - Connect IR emitter
(included) or receiver (AT-IR-CS-RX sold separately) to this port
6. HDBaseT IN - Connect a category cable from here to an AT-UHD-EX-100CE-TX (included in KIT) or
HDBaseT matrix
7. HDMI OUT - Connect HDMI or DVI (with adapter) display here
1 2
3
7 6 5 4