Atlona AT HD800 V3 - Manual (Page 5)

No. Resolution V Hz No. Resolution V Hz No. Resolution V Hz
1 480p 60 2 480i 60 3 576p 50
4 576i 60 5 720p 60 6 720p 50
7 1080i 60 8 1080i 50 9 1080p 60
10 1080p 50 11 1080p 24 12 640x480 60
13 800x600 60 14 1024x768 60 15 1280x800 60
16 1280x1024 60 17 1920x1200 60 18
720p
(3D Frame Packing)
60
19
720p
(3D Side-by-Side)
60 20
720p
(3D Top-to-Bottom)
60 21
720p
(3D Frame Packing)
50
22
720p
(3D Side-by-Side)
50 23
720p
(3D Top-to-Bottom)
50 24
1080p
(3D Frame Packing)
24
25
1080p
(3D Side-by-Side)
24 26
1080p
(3D Top-to-Bottom)
24
DC 5V
3D
PC
HD
BATT
LOW
BYPASS
PATTERN TIMING
SELECT
INFO
PATTERN
HDMI IN POWER
OFF
ON
LIFT UP
PUSH IN
HDMI OUT
AT-HD800
50Hz
60Hz
DC 5V
3D
PC
HD
BATT
LOW
BYPASS
PATTERN TIMING
SELECT
INFO
PATTERN
HDMI IN POWER
OFF
ON
LIFT UP
PUSH IN
HDMI OUT
AT-HD800
50Hz
60Hz
5
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
HDMI Cable Testing
Battery Door
Timing Chart
Important: Before testing the HDMI cables, ensure the AT-HD800 is not in 3D mode. If in 3D mode, connect
to any display and hold the timing select button for 3 seconds to reset to the display’s resolution (the
AT-DIS7-PROHD can be used for this step). Once out of 3D mode the AT-HD800 is ready to test the HDMI
cables.
The battery door can be found at the bottom of the HD800 under the signal LEDs and function
buttons. To remove the door, first take the protective rubber casing off. Find the button that
says “PUSH IN” and press it in with a hard tipped item, such as a pen or screwdriver (Do not use
fingernail or there is a risk of breakage). The latch should pop up and the door can be slid off.
To replace the battery door, slide the door back into place and press the latch slightly backwards.
Press down until the latch has snapped back into place.